Disc dryer technology scenarios: 1 Heating medium saturated steam, into the hollow shaft through the outer tube of the driven shaft of the rotary joint, from the hollow shaft respectively, into each of the heating disc into the condensate formed by ejecting means using the disc and the outside pressure difference and the heating of the disk rotates continuously discharged into hydrophobic systems. 2 Dial feeding device suspended asked to clean up the disk material is heated and dried, to improve the heat transfer efficiency of the disc; clean plate at both ends up dead ends, to avoid the accumulation of material. Disc dryer material through the extruder after the wet material into the disc continuous dryer; wet material distributed in layers of polyvinylidene fluoride ask disc drying equipment, continue to be heated disc, flip, push, wet material heat evenly, under negative pressure sodium bromate dryer, removing material in ethanol and adjust water through the material after drying off the wind, 迸 into the next process; mixed gas is withdrawn from the top of the device, L-phenylglycine after drying trap device, go condensed in the condenser, ethanol recovery, not pour exhaust recovery system to freeze; condensate discharge through hydrophobic systems. Three single dryer, Kinder dried (certified), dried by Changzhou Jianda Drying Equipment Co. Changzhou Jianda Drying Equipment Co., Ltd. (www.jian-da.com) is a leader in Changzhou, Jiangsu, drying equipment, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. Kinder dried in leadership with the staff warmly welcome all inquiries negotiations to create a better health future of drying.